This page covers removing the valve-integrated sensor — unscrew the union nut and lift the sensor from the rim bed. Caution: clean the valve hole before installing a new one.
| – |
Remove tyre pressure sensor-2-
from bed of wheel rim. |
Caution
| Before installing tyre pressure sensor, clean valve
hole. |
|
|
|
|
| – |
Install tyre pressure sensor-2-
along with a new seal and sealing washer and push it into wheel
rim at the points marked by -arrows-. |
| – |
Press tyre pressure sensor-2-
into the wheel rim at the points marked by
-arrows-. |
| Screw union nut -1- onto tyre
pressure sensor from outside. |
|
|
|
| – |
Press tyre pressure sensor-1-
onto bed of rim at the points marked by
-arrows- and tighten union nut to 8 Nm. |
Caution
| Tighten nut only to specified torque. |
| The sealing washer -2-
will be deformed slightly when tightened. |
| The sealing washer may be installed only once.
Install a new sealing washer with rubber seal every time
the part is fitted. |
| Further tightening of the union nut is not permitted
because the seal may be damaged, leading to leaks. |
|
| → Chapter „Assembly overview - tyre pressure sensor, tyre
pressure sensor with valve“ |
|
|
|
Questions & answers
Removing and installing tyre pressure sensor, tyre pressure sensor with valve — Volkswagen Golf Mk7
How do I remove a Golf Mk7 TPMS sensor with integrated valve?
Remove the tyre. Unscrew the valve nut from inside the rim, push the sensor/valve inward and remove. Fit a new seal ring on installation.
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Ca ...
Removing and installing tyre pressure sensor, tyre pressure sensor without
valve, customer service version