Using torque wrench -V.A.G 1783-, this page covers removing aerial amplifier -R24- — Note: amplifiers -R93- and -R84- follow a similar procedure.
| Special tools and workshop equipment
required |
|
|
|
| Torque wrench -V.A.G 1783- |
 Note
| Removal and installation of aerial amplifier -R24- are
described. Removal and installation of aerial amplifier 2 -R93-
and aerial amplifier 3 -R84- are carried out in the same way. |
| – |
Switch off ignition and all electrical consumers, and remove
ignition key. |
| Aerial amplifier -R24-/aerial amplifier 3 -R84- is located
on top left of rear lid. |
| – |
Remove rear lid trim (top)
→ General body repairs, interior; Rep. gr.70. |
| Aerial amplifier 2 -R83- is located on bottom right of rear
lid. |
| – |
Remove rear lid trim (bottom)
→ General body repairs, interior; Rep. gr.70. |
|
|
|
| – |
Release and detach connectors -arrows-
on aerial amplifier -R24-. |
|
|
|
| – |
Loosen securing bolt -arrow-. |
| – |
Pull out bolt with plate clamp and aerial amplifier -R24-. |
|
|
|
| – |
Push aerial amplifier -R24- in direction of arrow. |
| – |
Remove aerial amplifier -R24-. |
| Install in the reverse order of removal. When doing this,
note the following: |
|
|
|
| Component |
Specified torque |
| Bolt on aerial amplifier -R24- |
2 Nm |
Questions & answers
Removing and installing aerial amplifier -R24-/-R93-/-R84- — Volkswagen Golf Mk7
How do I remove the Golf Mk7 aerial amplifier?
Remove the C-pillar or D-pillar trim. Disconnect the aerial cables and connector, unbolt and remove.
1 -
Frequency modulation (FM) frequency filter in positive wire -R179-
On window frame to the left of the rear lid
FM trap circuit (+)
...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removin ...
