This page covers removing the active sound engine noise generator control unit -J943- on Golf GTD models — remove the C-pillar trim first, then the retaining bolts.
| – |
Remove C-pillar trim
→ General body repairs, interior; Rep. gr.70. |
|
|
|
| – |
Remove engine sound generator control unit -J943--1-
from side panel. |
| – |
Release and disconnect electrical connector
-2-. |
| Install in the reverse order of removal, observing the
following: |
| → Chapter „Overview of fitting locations – control units, rear“ |
|
|
|
Questions & answers
Removing and installing engine sound generator control unit -J943-, vehicles with active sound, Golf GTD — Volkswagen Golf Mk7
How do I remove the Golf Mk7 GTD active sound generator -J943-?
Located in the luggage compartment. Disconnect the connector, unbolt and remove. Generates synthesised engine sound through the speakers.
Special tools and workshop equipment
required
Feeler gauge
Removing
–
If fitted, re ...
Repairs to wiring harnesses and
connectors
Note
All instructions and notes regarding this chapter are
available under
U ...
