VW Golf Mk7 manualsGolf Mk7 / manual

Volkswagen Golf Mk7 Service & Repair Manual: Removing and installing relay and fuse carrier behind dash panel, RHD vehicles

This page covers the equivalent RHD procedure — Note: exact fuse assignment must be read from the specific carrier fitted.

Removing
–  With ignition switched off, disconnect earth cable from battery → Chapter.
–  Remove dash panel → General body repairs, interior; Rep. gr.70.
   

Removing and installing relay and fuse carrier behind dash panel, RHD vehicles

  Note
The exact assignment should be gleaned from the latest current flow diagram → Current flow diagrams, Electrical fault finding and Fitting locations.
Take photographs of the assignment, if necessary.
–  Press locking mechanism -5- on both sides and pull it in direction of arrow -C-.
–  Pull off connector -4- in direction of arrow -C-.
–  Release retaining tab -1- in direction of arrow -A-.
–  Release retaining tab -2- in direction of arrow -B-.
–  Release retaining tab -3- in direction of arrow -C-.
–  Pull fuse holder C -SC- towards rear -arrow D- out of bracket.
–  Disconnect electrical wiring.

 
Installing
Installation is carried out in the reverse sequence.

    Questions & answers

    Removing and installing relay and fuse carrier behind dash panel, RHD vehicles — Volkswagen Golf Mk7

    How do I remove the Golf Mk7 RHD dash panel fuse carrier?
    Mirrored from LHD. Same photograph-first recommendation.
    Removing and installing relay and fuse carrier behind dash panel, LHD vehicles
    Removing –  With ignition switched off, disconnect earth cable from battery → Chapter. –  ...

    Removing and installing fuse holder, battery
    Removing –  With ignition switched off, disconnect earth cable from battery → Chapter.     ...