WARNING
| Risk of death due to high voltage! Risk of injury
and environmental pollution! |
| Observe operation and safety notes for gas discharge
bulbs
→ Chapter. |
| It is essential that the battery earth cable is
disconnected before any work on parts of the gas
discharge headlight is performed. The parts are marked
with a yellow high voltage symbol. |
|
 Note
| Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way. |
| – |
Remove headlight
→ Chapter. |
|
|
|
| – |
Remove left gas discharge bulb control unit -J343--1-
from headlight. |
| – |
Press release buttons -4- and
-6-. |
| – |
Disconnect connectors -3- and
-5-. |
| Install in the reverse order of removal, observing the
following: |
Caution
| Make sure seal is correctly seated when installing
the gas discharge bulb control unit. The ingress of
water will lead to permanent damage to the headlight. |
|
| – |
Check seal between control unit and headlight for damage. |
| → Chapter „Assembly overview - headlight“ |
|
|
|
Questions & answers
Removing and installing gas discharge bulb control unit -J343-/-J344- — Volkswagen Golf Mk7
How do I remove the Golf Mk7 xenon ballast -J343-/-J344-?
Remove the headlight. Unbolt the ballast from the housing. Disconnect carefully — high voltage. A new ballast may need coding.
Note
Left cornering light bulb -L148- and right cornering light
bulb -L149- are only fitted on gas discharge headlights.
R ...
WARNING
Risk of death due to high voltage! Risk of injury
and environmental pollution!
...
Removing and installing bulbs for cornering light -L148-/-L149-
Removing and installing output module for headlight -J667-/-J668-