 Note
| Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous. |
|
|
|
| Rear left speed sensor -G46--1-. |
|
|
|
| – |
Disconnect connector -2- from
rear left speed sensor -G46-. |
| – |
Unscrew bolt -1- and pull speed
sensor out of wheel bearing housing. |
| Install in reverse order of removal, observing the
following: |
| – |
Before inserting speed sensor, clean inner surface of hole,
and coat speed sensor all over with high-temperature paste
G 052 112 A3. |
| → Chapter „Assembly overview - speed sensor on rear axle“ |
|
|
|
Questions & answers
Removing and installing speed sensor on rear axle -G44-/-G46- — Volkswagen Golf Mk7
How do I remove Golf Mk7 GTE rear ABS sensors?
Same as standard: disconnect, unbolt, pull out.
Note
Removal and installation is described for the front left
speed sensor. Removal and installation of the front right speed
sensor is analogous.
...
The lateral acceleration sender -G200-, the yaw rate sender
-G202- and the longitudinal acceleration sender -G251- are
installed together with the control unit for el ...
