Using torque wrench -V.A.G 1783-, this page covers removing the retainer for control unit -J525- — remove the control unit first, then fold back the floor covering and insulation.
| Special tools and workshop equipment
required |
|
|
|
| Torque wrench -V.A.G 1783- |
| – |
Removing digital sound package control unit -J525-
→ Chapter. |
|
|
|
| – |
Fold back floor covering and floor insulation from middle
tunnel and floor panel. |
| – |
Unscrew bolt -1- from middle
tunnel and nuts -2- from retainer. |
| – |
Remove retainer from digital sound package control unit
-J525--3-. |
| Install in the reverse order of removal. When doing this,
note the following: |
|
|
|
| Component |
Specified torque |
| Bolt
-1- |
6 Nm |
| Nuts -2- |
6 Nm |
Questions & answers
Removing and installing retainer for digital sound package control unit -J525- — Volkswagen Golf Mk7
How do I remove the Golf Mk7 -J525- retainer bracket?
Unbolt from the body panel after removing -J525-.
Special tools and workshop equipment
required
Protective cap for wiring harness connector -VAS 6223/9-
...
Front left treble loudspeakers -R20-/front right treble
loudspeakers -R22- are located in A-pillar trim.
Note
If the treble loud ...
Removing and installing digital sound package control unit -J525
Removing and installing front treble loudspeakers -R20-/-R22-