VW Golf Mk7 manualsGolf Mk7 / manual

Volkswagen Golf Mk7 Service & Repair Manual: Assembly overview - control unit and hydraulic unit, LHD vehicles

This assembly overview covers the LHD hybrid Volkswagen Golf Mk7 ABS unit: the brake line from the master cylinder's primary circuit, identified by its 6 mm diameter and M12×1 flare nut, torqued to 14 Nm.

Assembly overview - control unit and hydraulic unit, LHD vehicles

1 -  Brake line
From primary piston circuit of brake master cylinder to hydraulic unit.
Identification: Ш 6 mm and flare nut with thread M 12 x 1
14 Nm
2 -  Brake line
From secondary piston circuit of brake master cylinder to hydraulic unit.
Identification: Ш 6 mm and flare nut with thread M 12 x 1
14 Nm
3 -  Brake servo
Assembly overview → Chapter.
Checking brake servo → Vehicle diagnostic tester
Removing and installing → Chapter
4 -  ABS control unit -J104- and ABS hydraulic unit -N55-
Removing and installing → Chapter
5 -  Brake line
To rear right brake caliper
Identification: Ш 5.25 mm and flare nut with thread M 10 x 1
14 Nm
6 -  Brake line
To front left brake caliper.
Identification: Ш 5.25 mm and flare nut with thread M 10 x 1
14 Nm
7 -  Brake line
To front right brake caliper
Identification: Ш 5.25 mm and flare nut with thread M 10 x 1
14 Nm
8 -  Brake line
To rear left brake caliper
Identification: Ш 5.25 mm and flare nut with thread M 10 x 1
14 Nm
9 -  Brake line
To primary piston circuit of brake master cylinder
Identification: Ш 6 mm and flare nut with thread M 12 x 1
14 Nm
10 -  Brake line
To secondary piston circuit of brake master cylinder
Identification: Ш 6 mm and flare nut with thread M 12 x 1
14 Nm
11 -  Bracket
12 -  Bolt
8 Nm
13 -  Rubber damper
Ensure that rubber dampers of retainer are not pressed out of bracket when installing. After installation, check that the ABS hydraulic unit -N55- is firmly seated, or malfunction can occur.
14 -  Bracket
15 -  Nut
20 Nm
16 -  Brake system pressure accumulator -VX70-
Location → Chapter
Assembly overview → Chapter.
Removing and installing → Chapter
17 -  Brake line
To brake servo.
Identification: Ш 5.25 mm and flare nut with thread M 10 x 1
14 Nm
18 -  Brake line
To brake system pressure accumulator -VX70-
Identification: Ш 5.25 mm and flare nut with thread M 10 x 1
14 Nm

    Questions & answers

    Assembly overview - control unit and hydraulic unit, LHD vehicles — Volkswagen Golf Mk7

    What does the Golf Mk7 GTE LHD ABS assembly show?
    Hydraulic block, ECU, brake lines, mounting bracket. GTE-specific part numbers for the integrated regen braking controller.
    Control unit and hydraulic unit
    ...

    Assembly overview - control unit and hydraulic unit, RHD vehicles
    1 -  Brake servo and brake master cylinder Assembly overview → Chapter. Checking brake servo → Vehicle diagnos ...

    Other materials: