Volkswagen Golf Mk7 Owners Manual: Checking the coolant level and refilling coolant
Fig. 195 shows the level mark and Fig. 196 the cap on the Volkswagen Golf Mk7 coolant expansion tank. The coolant warning lamp lights if the level is too low — this page gives the safe procedure for checking and topping up, including the precautions needed around a hot, pressurised system.
Fig. 195 In the engine compartment: mark on the coolant expansion tank
Fig. 196 In the engine compartment: coolant expansion tank cap
First read and observe the introductory information
and safety warnings The warning lamp for the engine coolant will light up if the engine coolant level is too low.
Preparation
- Park the vehicle on a firm and level surface.
- Allow the engine to cool down .
- Open the bonnet
.
- The coolant expansion tank has the
symbol
on its cap .
Checking the coolant level
- Check the coolant level at the side marking of the expansion tank when the engine is cold .
- Refill the coolant if the liquid level is below the minimum marking (min). When the engine is warm, the coolant level may be slightly above the top end of the marked area.
Refilling coolant
- Always protect your hands and arms from hot coolant or steam by placing a suitable cloth on the cap of the coolant expansion tank.
- Unscrew the cap carefully .
- Refill only new coolant according to the Volkswagen specification ( ) .
- Only top up coolant if there is coolant residue in the expansion tank. If this is not observed, the engine could be damaged. If you cannot see any coolant in the expansion tank do not drive on. Seek professional assistance.
- If you can see coolant residue in the expansion tank, top up coolant until the level remains stable.
- The coolant level must be between the marks on the expansion tank . Do not fill up over the top line of the marked area !
- Close the cap tightly.
- If in an emergency you do not have access to the coolant of the required specification ( ), do not use any other coolant additive. Instead, initially refill with distilled water only. Then add the correct proportion of coolant additive as soon as possible .
WARNING
- Never open the bonnet if you can see or hear steam or engine coolant coming out of the engine compartment. Always wait until no escaping steam or coolant can be seen or heard.
- Always allow the engine to cool down completely before carefully opening the bonnet. Hot components can burn the skin.
- Before opening the bonnet once it has cooled down:
- Switch on the electronic parking brake and move the selector lever to position P or move the manual gear lever to the neutral position.
- Remove the vehicle key from the ignition lock.
- Always keep children away from the engine compartment and never leave the vehicle unattended.
- The engine cooling system is under pressure when the engine is hot. Never
open the cap of the coolant expansion tank when the engine is hot. Coolant may
spray out and cause serious burns and injuries.
- Turn the cap slowly and very carefully anticlockwise while exerting some downward pressure on the cap.
- Always protect the face, hands and arms from hot coolant or steam with a large, thick cloth.
- When refilling, do not spill any service fluids on engine components or on the exhaust system. The spilt service fluids can start a fire. In certain circumstances, the ethylene glycol in the engine can catch fire.
NOTICE
- Refill only with distilled water. All other types of water can cause corrosion in the engine due to the chemical components contained therein. This can also lead to engine failure. If any other type of water is refilled, the fluid in the engine cooling system should be completely replaced immediately by a qualified workshop.
- Do not fill coolant above the top of the marked area . Otherwise the excess coolant will be pressed out of the cooling system when the engine is hot and could cause damage.
- If a large amount of coolant has been lost, do not refill the coolant until the engine has cooled completely. Heavy coolant loss is an indication of leaks in the engine cooling system. The engine cooling system should be checked by a qualified workshop as soon as possible. Failure to do so can result in engine damage.
- Do not top up with coolant if there is no more coolant in the expansion tank. Air could enter the cooling system. Do not drive on! Seek expert assistance. Failure to do so can result in engine damage.
- When refilling operating fluids, please ensure that the correct container is filled. The use of incorrect operating fluids can result in serious faults and engine damage.
Questions & answers
Checking the coolant level and refilling coolant — Volkswagen Golf Mk7
How do I check the Golf Mk7 coolant level?
With the engine cold, look at the expansion tank in the engine bay. The coolant should be between the MIN and MAX marks. If it is below MIN, top up with the correct mixture.
Where is the Golf Mk7 coolant expansion tank?
In the engine bay, typically on the left side. It is a translucent plastic container with MIN and MAX markings, and has a screw cap with a warning label.
What should I do if the Golf Mk7 coolant level drops repeatedly?
A recurring drop indicates a leak in the cooling system — hoses, radiator, head gasket or water pump. Have it inspected at a workshop before the engine overheats.
Can I add water to the Golf Mk7 cooling system in an emergency?
In an absolute emergency, clean water can be added to reach the next workshop. But the concentration of G 13 must be corrected as soon as possible to restore frost and corrosion protection.
