| Special tools and workshop equipment
required |
| Calliper square -VAS 6335- |
| – |
Remove adaptive cruise control unit -J428-
→ Chapter. |
|
|
|
| – |
Turn quick-release fasteners -2-
in -direction of arrow-. |
| – |
Pull quick-release fasteners -2-
off adjustment screws -1-. |
| – |
Remove retaining plate -3- from
adaptive cruise control unit -J428--4-. |
| Install in the reverse order of removal, observing the
following: |
 Note
| Renew quick-release fasteners -2-. |
| The adjustment screws -1- in
the adapter frame are pre-adjusted. Correct the adjustment as
required
→ Fig.. |
|
|
|
| Adjusting adjustment screws |
| – |
Using digital calliper -VAS 6335-, measure setting
-a- of all adjustment screws and
correct, if necessary. |
| Dimension -a- = 40.3 mm ±
0.5 mm |
| – |
Set retaining plate -1- on
quick-release fasteners -2-. |
|
|
|
| – |
Push new quick-release fasteners -2-
onto adjustment screws and fixed mounting on adapter frame
-3-. |
| – |
Turn quick-release fasteners -2-
on back of retaining plate -1- to
stop in direction of arrow -A-. |
| – |
Install adaptive cruise control unit -J428-
→ Chapter. |
| – |
Calibrate adaptive cruise control
→ Chapter. |
|
|
|
Questions & answers
Removing automatic distance control unit from and installing on retaining plate, variant 2 — Volkswagen Golf Mk7
Is there a second variant 2 ACC mounting procedure?
Yes. Some variant 2 units have a different retaining plate design. Check the part number before ordering.
Note
If the automatic distance control unit -J428- is renewed,
start the respective function → Vehicle
diagnostic tester.
...
Removing
–
Remove adaptive cruise control unit -J428-
→ Chapter.
...
Removing automatic distance control unit from and installing on retaining
plate, variant 2
Removing automatic distance control unit from and installing on adapter
frame, variant 2