VW Golf Mk7 manualsGolf Mk7 / manual

Volkswagen Golf Mk7 Service & Repair Manual: Removing and installing data bus diagnostic interface -J533-

Note: select "Renew" via Guided Fault Finding when replacing this unit. This page covers removing the data bus diagnostic interface -J533- — unplug the electrical connector first.

  Note
When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode → Vehicle diagnostic tester.
Removing
   
–  Unplug electrical connector -1- by reaching upwards behind pedal bracket.
–  Press locking detent to disconnect and pull off connectors.
–  Disengage catches -arrows-.
–  Pull data bus diagnostic interface -J533--3- downwards off bracket -2-.
Installing
Install in the reverse order of removal, observing the following:
Specified torques
→ Chapter „Assembly overview - data bus diagnostic interface“
 

Removing and installing data bus diagnostic interface -J533-

    Questions & answers

    Removing and installing data bus diagnostic interface -J533- — Volkswagen Golf Mk7

    How do I remove the Golf Mk7 gateway -J533-?
    Behind the dash panel. Disconnect all CAN bus connectors, unbolt and remove. A new gateway must be coded with the vehicle's full module list.
    Removing and installing onboard supply control unit -J519-, RHD vehicles
      Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode &# ...

    Removing and installing bracket for onboard supply control unit -J519-, LHD vehicles
    Removing –  With ignition switched off, disconnect earth cable from battery → Chapter. –  ...

    Other materials: