| The following steps are required if one or more driver
assist systems on the vehicle are to be calibrated via the
“Quick-start” procedure (i.e. without first checking and
adjusting the wheel alignment): |
| Before driving the vehicle onto the alignment platform, make
sure there is sufficient space between the vehicle and the
calibration unit. The distance between the calibration unit and
the vehicle must be 120 cm ± 2.5 cm. |
| If the available space is not adequate, move the vehicle
backwards on the alignment platform as required. This allows the
use of the respective floor area. |
| Before starting calibration, read out event memory and
rectify any faults. |
| Vehicle accurately aligned, suspension bounced and rocked
several times. |
| When checking wheel alignment, ensure that sliding plates
and turn tables are not touching end stop. |
| Connect battery charger
→ Vehicle electrics; Rep. gr.27. |
| Move front wheels to straight-ahead position. |
| Connect → Vehicle
diagnostic tester to vehicle, route diagnostic cable
through open door window. |
| Vehicle exterior lighting switched off. |
| All doors of vehicle are closed. |
| Press button to select required calibration on wheel
alignment computer. |
|
|
|
Questions & answers
Test preparations, wheel alignment with driver assist systems — Volkswagen Golf Mk7
How do I prepare for Golf Mk7 alignment with assist systems?
Same as without, plus calibrate the steering angle sensor and front camera after alignment if Lane Assist or ACC is fitted.
Special tools and workshop equipment required
Wheel alignment computer -V.A.G 1813F- or VW/Audi-approved wheel
alignment units
Brake pedal depressor ...
These specifications apply to all engines.
Explanations regarding PR numbers
→ Chapter „Vehicle data sticker“.
Front axle
Basic
...
