Using torque wrench -V.A.G 1783- and torque screwdriver -VAS 6494-, this page covers removing output module 1 for the left LED headlight -A31-/-A27- — described for the left side.
| Special tools and workshop equipment
required |
|
|
|
| Torque wrench -V.A.G 1783- |
|
|
|
| Torque screwdriver -VAS 6494- |
 Note
| Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way. |
| – |
Remove headlight
→ Chapter. |
|
|
|
| – |
Pull output module 1 for left LED headlight -A31--1-
off headlight. |
| – |
Press release button -4- in
direction of arrow -A-. |
| – |
Disconnect electrical connector -3-. |
| Install in the reverse order of removal, observing the
following: |
Caution
| Make sure the seal is correctly seated when
installing the output module 1 for left LED headlight
-A31-. The ingress of water will lead to permanent
damage to the headlight. |
|
| – |
Check seal between output module 1 for left LED headlight
-A31- and headlight for damage. |
| → Chapter „Assembly overview - LED headlights“ |
|
|
|
Questions & answers
Removing and installing output module 1 for left LED headlight -A31-/-A27- — Volkswagen Golf Mk7
How do I remove the Golf Mk7 LED headlight output module 1?
Remove the headlight. Handle with ESD precautions. Unbolt and disconnect.
WARNING
Risk of death due to high voltage! Risk of injury
and environmental pollution!
...
Note
Control motor sender for left VARILIS headlight -G695- and
control motor sender for right VARILIS headlight -G696- are only
fitted on gas di ...
Removing and installing output module 2 for headlights,
»R«
Removing and installing control motor sender for VARILIS headlight
-G695-/-G696-