 Note
| Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way. |
| – |
Turn light switch to “0” position. |
Caution
| Danger of damage to component surfaces. |
| When using leverage tools, mask visible areas of the
component with commercially available adhesive tape. |
|
|
|
|
| – |
If needed, apply a narrow screwdriver at opening on side.
|
| – |
Press off cover -1- in
-direction of arrow-. |
|
|
|
| – |
Disconnect electrical connector -2-. |
| – |
Press catches -3- in direction
of arrows -A-,
-B- and -C-,
respectively. |
| – |
Pull bulb carrier -1- out of
tail light. |
|
|
|
| – |
Pull tail light bulb -1- out of
bulb carrier -2-. |
| Install in the reverse order of removal, observing the
following: |
Caution
| Risk of damage to the bulb. |
| Do not touch the glass part of the bulb with bare
fingers. Fingers leave traces of grease on the glass
bulb, which vaporise when the bulb is switched on and
cause the glass bulb to cloud over. |
| Wear, for example, clean fabric gloves when
inserting bulbs. |
|
|
|
 |
Questions & answers
Removing and installing tail light bulb -M2-/-M4- — Volkswagen Golf Mk7
How do I change the Golf Mk7 tail light bulb?
Twist the holder from behind the cluster, pull out and swap. Each position has a different bulb type.
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
...
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
...
