| – |
With ignition switched off, disconnect earth cable from
battery
→ Chapter. |
| – |
Remove dash panel
→ General body repairs, interior; Rep. gr.70. |
|
|
|
| – |
Cut through cable tie -arrow-. |
| – |
Disengage fuse holder C and push to side
→ Chapter. |
| – |
Disconnect connector for front parking aid warning buzzer
-H22-
→ Chapter. |
| – |
Disconnect connector for onboard supply control unit -J519-
→ Chapter. |
| – |
Disconnect connector for parking aid control unit
-J446-/park assist steering control unit -J791-
→ Chapter. |
| – |
Release locking mechanism on bracket and press out bracket
to remove diagnostics connector. |
|
|
|
| – |
Unscrew bolts -2, 3 and 6-. |
| – |
Push bracket -1- forwards out
of central tube until centring pins -4, 5-
are disengaged. |
| – |
Cut through cable ties -arrows-. |
| – |
Move electrical wiring harness clear at mounting. |
| – |
Take out bracket towards passenger compartment. |
| Installation is carried out in the reverse sequence. |
|
|
|
Questions & answers
Removing and installing bracket for onboard supply control unit -J519-, LHD vehicles — Volkswagen Golf Mk7
How do I remove the Golf Mk7 -J519- bracket (LHD)?
Remove -J519- first. Unbolt the bracket from the cross-car beam.
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
&# ...
Removing
–
With ignition switched off, disconnect earth cable from
battery
→ Chapter.
– ...
Removing and installing data bus diagnostic interface -J533-
Removing and installing bracket for onboard supply control unit -J519-, RHD
vehicles