 Note
| Observe the latest operating instructions for vehicle
diagnosis tester, which are displayed after selecting the
“Administration” and “Operating Manual” keys. |
| Special tools and workshop equipment
required |
|
|
|
| Vehicle diagnostic tester |
|
|
|
| Diagnostic cable -VAS 5051/6A- (5 m) |
| Diagnostic cable -VAS 5051/5A- (3 m) |
Note
| Only these cables are to be used for diagnosis, as they are
the only ones fitted with CAN wiring and therefore allowing CAN
diagnosis and/or CAN communication. |
| Connecting vehicle diagnostic tester: |
| – |
Vehicles with automatic gearbox, move selector lever to
position “P” or “N”. |
| – |
Vehicles with manual gearbox, move gear lever to neutral
position. |
|
|
|
| – |
With ignition switched off, connect vehicle diagnosis tester
using diagnostic cable -VAS 5051/6A- to diagnostic interface
-arrow- in vehicle. |
| – |
Switch off all electrical consumers. |
Note
|
All other and the following vehicle diagnostic, testing and
information systems or vehicle diagnostic and service
information systems are connected accordingly in the sequence
described above. |
|
|
|
Questions & answers
Connecting vehicle diagnostic tester — Volkswagen Golf Mk7
How do I connect the Golf Mk7 diagnostic tester?
Plug the diagnostic cable into the 16-pin OBD-II port under the dash on the driver side. The tester communicates via CAN bus.
WARNING
During testing or measuring operations using a
vehicle diagnostic information system there is a risk of
...
–
Apply handbrake.
–
Vehicles with automatic gearbox, move selector lever to
position “P” or “N”.
...
