Volkswagen Golf Mk7 Service & Repair Manual: Removing automatic distance control unit from and installing on retaining plate, variant 2

Note: if the ACC unit -J428- is renewed, start the corresponding function via the diagnostic tester. Using torque wrench -V.A.G 1331-, this page covers the variant 2 retaining plate procedure.

Note If the automatic distance control unit -J428- is renewed, start the respective function → Vehicle diagnostic tester. Special tools and workshop equipment required

Torque wrench -V.A.G 1331- Removing

–  Remove bolts -1-. –  Remove adaptive cruise control unit -J428- with retaining plate -3-. –  Disconnect electrical connector -2-. Installing Install in the reverse order of removal, observing the following: –  Calibrate adaptive cruise control → Chapter. Specified torques → Chapter „Overview of fitting locations – adaptive cruise control, variant 2“

Questions & answers

Removing automatic distance control unit from and installing on retaining plate, variant 2 — Volkswagen Golf Mk7

How do I separate the Golf Mk7 ACC unit from its plate (variant 2)?

Different bolt positions from variant 1. Note alignment marks.

Removing automatic distance control unit from and installing on retaining plate, variant 1

Removing: → Anchor Installing: → Anchor Adjusting adjustment screws: → Anchor ...

Removing automatic distance control unit from and installing on retaining plate, variant 2

Special tools and workshop equipment required Calliper square -VAS 6335- Removing –  ...

Other materials:

• Removing and installing automatic distance control unit, variant 1
• Overview of fitting locations – adaptive cruise control, variant 1
• Removing automatic distance control unit from and installing on retaining plate, variant 2
• Removing automatic distance control unit from and installing on retaining plate, variant 1
• Calibrating adaptive cruise control