VW Golf Mk7 manualsGolf Mk7 / manual

Volkswagen Golf Mk7 Owners Manual: Changing a wheel

Fig. 226 shows removing the wheel bolts with the screwdriver handle on the Volkswagen Golf Mk7. This page gives the full removal sequence — read the checklist, loosen the bolts, jack up the car, then fully remove the bolts using the hexagonal socket in the screwdriver handle.

Fig. 226 Changing a wheel: removing the wheel bolts with the screwdriver handle

First read and observe the introductory information and safety warnings

Removing the wheel

  • Read the checklist.
  • Loosen the wheel bolts.
  • Jack up the vehicle.
  • Using the hexagonal socket in the screwdriver handle , completely unscrew the loosened wheel bolts and place them on a clean surface.
  • Remove the wheel.

Fitting the spare wheel or temporary spare wheel

Note any specific tyre running direction .

  • Position the spare wheel / temporary spare wheel.
  • Insert the anti-theft wheel bolt using the adapter at position or ③ and tighten it slightly in a clockwise direction.
  • Screw in all the other wheel bolts in a clockwise direction and use the hexagonal socket in the screwdriver handle to tighten them gently.
  • Lower the vehicle with the jack.
  • Use the box spanner to tighten all the wheel bolts securely in a clockwise direction . Do not tighten the bolts in clockwise or anticlockwise sequence. Tighten them in diagonal sequence.
  • Fit the cover caps, centre covers or wheel covers.

WARNING

Incorrect torque or incorrect use of wheel bolts can lead to a loss of control of the vehicle, cause accidents and serious injuries.
  • Always keep all wheel bolts and threads in the wheel hubs clean and free from oil and grease. The wheel bolts must be easy to turn and be tightened to the specified torque.
  • The hexagonal socket in the screwdriver handle should only be used for turning wheel bolts, not use for loosening or tightening them.

    Questions & answers

    Changing a wheel — Volkswagen Golf Mk7

    How do I remove a Golf Mk7 wheel?
    After loosening the bolts and jacking up, unscrew the bolts fully using the screwdriver handle as a ratchet, then pull the wheel straight off the hub.
    How do I fit the Golf Mk7 spare or new wheel?
    Lift the wheel onto the hub studs, hand-tighten the bolts in a star pattern, lower the car off the jack, then torque the bolts to 120 Nm.
    What should I check after fitting a Golf Mk7 wheel?
    Confirm all bolts are torqued, the hubcap or bolt caps are refitted, tools are stowed, and the tyre pressure is correct. Re-torque the bolts after 50 km.
    Checklist
    To ensure your own safety and the safety of your passengers, observe the following actions in the specified order : Find a firm and level surface suitable for lifting the vehicle. Swit ...

    After changing a wheel
    First read and observe the introductory information and safety warnings Clean the tools as necessary and place them back in the foam rubber holder in the luggage compartment. Stow the spa ...

    Other materials: