| Special tools and workshop equipment
required |
|
|
|
| Torque wrench -V.A.G 1331- |
|
|
|
| Torque wrench -V.A.G 1332- |
| – |
With ignition switched off, disconnect earth cable from
battery -A-
→ Chapter. |
| Vehicles with air filter housing installed in front of
battery |
| – |
Remove air filter housing
→ Rep. gr.23. |
| Continued for all vehicles |
| – |
Remove noise insulation
→ General body repairs, exterior; Rep. gr.66. |
|
|
|
| – |
If installed, unscrew nut -2-
from lower bolt for starter -B--1-. |
| – |
If fitted, remove earth cable -3-. |
| – |
Remove bolt -4- for starter -B--1-. |
|
|
|
| – |
If fitted, unscrew nut -1- from
upper securing bolt of starter -B-. |
| – |
If fitted, remove earth cable -2-. |
|
|
|
| – |
Disconnect electrical connector -3-. |
| – |
Unscrew nut -5- and remove
terminal 30/B+. |
| – |
Remove bolt -1- for starter -B--2-. |
| – |
Remove starter -B--2- upwards. |
| Install in the reverse order of removal, observing the
following: |
| → Chapter „Assembly overview - starter“ |
| – |
Reconnect battery -A-
→ Chapter. |
|
|
|
| Cruise control system (CCS) |
 Note
| All instructions and notes regarding this chapter are
available under
→ Electrical System, General Information; Rep. gr.27. |
|
|
|
Questions & answers
Removing and installing starter, vehicles with double clutch gearbox (DQ250-6F) — Volkswagen Golf Mk7
How do I remove the Golf Mk7 starter (DQ250 DSG)?
Different access route from DQ200 due to the wet-clutch housing. Disconnect battery, B+ and connector, unbolt and remove.
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
...
Removing and installing starter, vehicles with double clutch gearbox
(DQ200–7F)