Volkswagen Golf Mk7 Service & Repair Manual: Removing and installing parking aid control unit -J446-, RHD vehicle

The same "Renew" function selection applies for RHD models — this page covers removing control unit -J446-, starting with the footwell cover.

Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode → Vehicle diagnostic tester. Removing –  Remove footwell cover on driver side → General body repairs, interior; Rep. gr.68.

–  Release and pull out spreader rivets -2-. –  Remove control unit -1-. –  Disconnect connectors -3 and 4-.

–  To do so, press locking detent -1-, swing retainer in -direction of arrow- and pull off connector. Installing Installation is carried out in the reverse sequence.

Questions & answers

Removing and installing parking aid control unit -J446-, RHD vehicle — Volkswagen Golf Mk7

How do I remove the Golf Mk7 ParkPilot -J446- (RHD)?

Mirrored position from LHD. Same coding requirement.

Removing and installing parking aid control unit -J446-, left-hand drive vehicle

  Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode &# ...

Removing and installing front parking aid warning buzzer -H22-, LHD vehicles

Removing –  Remove trim under dash panel → General body repairs, interior; Rep. gr.68.     ...

Other materials:

• Removing and installing front parking aid senders
• Removing and installing rear parking aid senders
• Assembly overview - front parking aid, LHD vehicles
• Removing and installing front parking aid warning buzzer -H22-, RHD vehicles
• Assembly overview - rear parking aid, LHD vehicles